Wavelength: 650nm; 940nm
1086 lamps with 5 light pads (three sizes) for different body parts
Treatment mode: continuous; pulse
Theory
The Maxlipo Light delivers both 650nm and 940nm light via high-powered, German-made, surface mount microchip lamps that are imbedded in a soft and flexible pad. This pad can easily be applied to any part of the body. Because of the Maxlipo Light’s proprietary reflective coating, the light that would normally bounce off the skin is reflected back, resulting in a much higher retention of light energy than with other similar devices. No other system has this reflective coating. Maxlipo Light temperature is between 43-50 degree, actual skin contact temperature is 42-45 degree. The treatment is painless, no discomfort, and can be safely operated for clients and operators.
Unlike ultrasound, radio frequency, laser light and freezing, the system do not cause cellular damage. Quite the opposite, non-invasive Maxlipo Light has been shown to promote a natural response within cells based on the wavelength of the light energy used and the type of cell it reaches. Dual wavelengths(650nm and 940nm) have been used in a wide range of therapies that promote some form of healing response.
The design of the Maxlipo Light pads that allow for better light delivery and retention within the tissue has been clinically proven to provide a superior result with consistent treatment outcomes. No other pad-based device can make these claims.
Application
The Maxlipo Light is used as a non-invasive dermatological aesthetic treatment for the reduction of circumference of the hips, waist and thighs. 650nm and 940nm(invisible light) stimulate the lymph drainage and reduce the cellulite, and the 940nm light penetrates deeper into adipose tissue.
It is also for the temporary relief of minor muscle and joint pain, arthritis, muscle spasms, relieving stiffness, promoting the relaxation of muscle tissue and to temporarily increase local blood circulation.
Parts Introduction
Treatment Areas
Parameters
Wavelength | 650nm, 940nm |
Lamp Source | Imported chips for assemble |
Lamp Type | Low intensity diode |
Quantities of Lamps | 1086pcs with 5 pcs Light pads |
Each Lamp Energy | 200MW |
Working Mode | Continuous and Pulse |
Treatment Pads | 5pcs (1 large, 2 medium, 2 small) |
Touch Screen | 8 inch Touch Screen |
Cooling System | Air Cooled |
Voltage | 100-130V/200V-230V; 50Hz-60Hz |
Safety | On Board Diagnostics |
Classification | Electrical Class Ⅱ, Type B applied part |
Ingress Rating | IPXO |
Environmental Requirement | 10。C to 40。C. Non-condensing humidities below 75% RH |
CE | CE with LVD and EMC |
Machine Packing Size | 40cm*39cm*31cm |
Cart Package size | 66*62cm*42cm |
G. W. | Host:6KG; Cart and Pads:15kg |
Input Power | ≤300W |
Operation